Sean Meighan
Software => Bugs in xLights/Nutcracker => Topic started by: dan@ on June 16, 2015, 04:41:57 PM
-
When I reopen Xlights Ver 4.1.5 I have to reenter my lighting network. It is not saving my channel setup. The directories are being saved. The models are saved. But not my channels. When I open it gives me a pop up that. "These models extend beyond the number of configured channels (0)"
-
If you are hitting the save setup button after you enter your channel config the only time I get that message is when I mess up a channel number in my models. Last time I had that happen I was experimenting with different matrix configs and did not pay attention to the ending number of a large matrix. I would guess you added a model that caused you exceed your network config and I don't think that is checked except when you start the program so you could add a model that went beyond your config and you won't get an error until you close and reopen nutcracker.
-
When I reopen Xlights Ver 4.1.5 I have to reenter my lighting network. It is not saving my channel setup. The directories are being saved. The models are saved. But not my channels. When I open it gives me a pop up that. "These models extend beyond the number of configured channels (0)"
Hi,
After entering the channel information on the setup page - you need to explicitly save the setup on that screen as otherwise it does not get saved and there is no warning message about that when exiting.