Sean Meighan

Software => Xlights Test => Topic started by: iDooT3 on September 11, 2015, 07:45:27 AM

Title: Lights don't work
Post by: iDooT3 on September 11, 2015, 07:45:27 AM

Newbie to xlights, can’t get lights to work at all.

I’m using an ECG-P2 controller, the lights do work if I enable testpattern but I get absolutely nothing trying to use test in xlights. The only lights I have connected are one of my Christmas trees (unv 12 & 13). I’ve tried multicast and unicast and nothing seems to work.
Attached pictures show my configuration. What am I missing – Thanks for any help.

Title: Re: Lights don't work
Post by: bigstott on September 11, 2015, 08:43:16 AM

Check and make sure your model is setup correctly. for your test in XL select all. That way all channels defined will be given a signal. If it works then, then you have an issue in how the model is setup.

Two if I am not mistaken your submask should be 255.255.255.0. Try that as well.

Title: Re: Lights don't work
Post by: iDooT3 on September 11, 2015, 09:10:46 AM

thanks, but didn't work. The "Tips for using current tap" mentions I should click the output to lights box, any ide where that check box is?

Title: Re: Lights don't work
Post by: iDooT3 on September 11, 2015, 09:13:22 AM

I found it, it looks so cool :)