Sean Meighan
Hardware => General hardware => Topic started by: djmc2002 on October 18, 2015, 10:56:18 PM
-
Ok what I am I missing here.
I have 3, 27 channel controllers set up in nutcracker starting at channel 81.
I have on the set up page them starting at channel 81 on universe 2. (universe 1 is 80 channels of LOR) On the actual board I have the dip switch set as follows 1,5,7 on all others off.(which I believe should be the setting for 81) The e1.31 goes from my computer to my diyledexpress bridge and out of bridge on output 2 (which I have setup starting at 81)
On the controller I get a activity (red led) that flashed every second or so.
When I go to xlights and try and test I get nothing. What am I doing incorrect.
Could I have bad dip switch block, or is some bone head thing I'm missing.
BTW when I set the controller dip to 1 and 10 on I get Red lights on my nodes.
Thanks
-
Who makes the 27 channel controller?
-
as much as I love xlights, I prefer da_e131 for testing.
http://www.da-share.com/software/da_e131/
Im at work so I cant look at the screens but do you have the output set to enabled on the settings tab? Also you do have the control lights turn on?
-
Who makes the 27 channel controller?
Purchased from Paul, so it is Ray look alike. Also strange thing is used it all last year, all be it on a different channel and driven from LOR.
-
Start your output from the bridge at 1, not 81. It is shifting the output count.
-
got it. I figured that out while I was AFK. Thank you so much!! I knew it was some bonehead move I'd made! :o