Sean Meighan

General => Lights => Topic started by: Broadway Lights on November 06, 2015, 09:55:25 AM

Title: Pixels node for null pixels
Post by: Broadway Lights on November 06, 2015, 09:55:25 AM
I have pixel strips for my arches they are 3 pixels per section 30 in a stip but my arches are about 25 feet from controller can i use nodes as null pixes to get to the stipes then tie into the stip
Thanks Robin

Sent from my SM-G920P using Tapatalk

Title: Re: Pixels node for null pixels
Post by: JonB256 on November 06, 2015, 11:32:48 AM
Depending on the controller, try using CAT5 wire to carry the signal. Odds are good that it will work at 25 feet.

From a Falcon F16v2 (which, admittedly already is pretty good at distance) I controlled a string at the end of a 110ft CAT5.  (power was way down, but the data got there perfectly)
Title: Re: Pixels node for null pixels
Post by: Broadway Lights on November 06, 2015, 01:35:19 PM
Using sandevicrs  but question is using nodes with a strip both w2811

Sent from my SM-G920P using Tapatalk

Title: Re: Pixels node for null pixels
Post by: gerry on November 06, 2015, 01:37:52 PM
Hi , yes u can  use  the nodes as long as the protocol is the same  (the nodes and the ones for the arches) e.g. are both WS2811 .
Title: Re: Pixels node for null pixels
Post by: Broadway Lights on November 06, 2015, 03:03:06 PM
Thanks

Sent from my SM-G920P using Tapatalk