Sean Meighan

Welcome => Do You Need Help? Post it here => Topic started by: rfallatt on November 11, 2015, 11:21:13 PM

Title: RPM E1.31 Bridge
Post by: rfallatt on November 11, 2015, 11:21:13 PM

I have been trying to get xlights to send Data to my RPM E1.31 Bridge with no success.
To ensure I was doing things correctly I set up a DIY LED express E1.31 Bridge and it worked properly.
Is it possible that the RPM bridge will not work with XLIGHTS?


This is my RPM setup page:

This is my DIYLEDEXPRESS setup page


You can see all the set ups are the same except for the IP address and note the "packets received"

I also did a communication test, where I pinged both bridges and they both were successful.

Any thoughts?
Does anybody use a RPM bridge with X lights?



Sent from my iPhone using Tapatalk

Title: Re: RPM E1.31 Bridge
Post by: JerryPlak on November 12, 2015, 04:17:46 AM

can you also post a Screenshot of your Xlight network set up page.
You may or may not know that the RPM E1.31 Bridge only receives multicast data it is not capable for unicast data.

Title: Re: RPM E1.31 Bridge
Post by: rfallatt on November 12, 2015, 06:33:38 AM

Oh I did not know that!
That's it! I have been setting it for unicast


Sent from my iPhone using Tapatalk

Title: RPM E1.31 Bridge
Post by: rfallatt on November 12, 2015, 07:37:12 AM

I tried sending it to multicast I  will attach a picture shortly I didn't make a difference


Sent from my iPhone using Tapatalk

Title: Re: RPM E1.31 Bridge
Post by: rfallatt on December 13, 2015, 06:56:55 PM

Status update. threw out the RPM Bridge and bought a DIYLEDEXPRESS E1.31 Bridge... all is well