Sean Meighan
Software => Xlights Setup => Topic started by: needbrew on December 29, 2015, 03:38:57 PM
-
Hi All,
I have another noob question. I have put together a spreadsheet like the one used in the video https://vimeo.com/130035888. My question is how does this translate to the Set-up tab if I am using a Falcon F16-V2 as my controller. I have broken up my display into zones so that the data signal does not have to go all over my house. Do I map the actual channels in the set-up, or do I have to worry about universes and the 170 channel limits? I Guess I am missing how I get from the logical model layer, where the channels are sequential, to the actual set-up.
thanks in advance
-
Hi,
On the xl setup tab , you map the channels to the Universes (you actually indicate that Universe 10 contains channels 1 -99 , U 11= 100 -250 etc)
Now on the F16 , you then map for each physical output , which universe is supported and how many pixel nodes (where a node is 3 channels).
So
Port 1 is Universe 10 , start Channel 1 Pixel count 33
Port 2 is Universe 11 , start Channel 100 Pixel count 50
-
Thanks