Sean Meighan
General => The Water Cooler => Topic started by: needbrew on August 29, 2016, 04:30:58 AM
-
Hi All,
Looking for ways that people hang the 42" wreath. Mine will be in a large window outside so I need to make sure it does not get messed up in the winds.
Would be interested to hear how others are doing it.
Thanks
Mike
-
I don't own the Boscoyo wreath but would recommend the 'Command" strips from 3M for the bottom braces. You could hang the wreath from the top of the window frame. I do something similar with a smaller wreath on my front door.
Steve
-
I have screws in my rock front at strategic points and then I use bailing wire to attach to models and then string them to the strategic screw anchor points.
-
Does the wire not cut into the wreath if it gets windy?
-
My Chromaflakes hang beneath my arches. I put a piece of paracord thru an open rib and tie each end separately to the arch. That keeps them from spinning. I have not noticed any problem with the wind blowing them back and forth like a swing, but that may be minimized because I have both input and output leads that dangle down to the ground.
-
Where do you get your paracord from?
-
Home Depot has some, but I bought mine from the local ARMY/NAVY surplus store. I seem to recall seeing it at Lowes also. Or if you have a camping center near you.
Be sure to burn the ends after you cut it to keep it from unraveling.
-
Does the wire not cut into the wreath if it gets windy?
no
-
Thanks for the assistance