Sean Meighan

Software => LOR => Topic started by: zanclus on September 09, 2014, 03:13:54 PM

Title: LOR Clipboard
Post by: zanclus on September 09, 2014, 03:13:54 PM

Hi  I  seem  to  be  puzzled a bit  here. I  created text in  Nutcracker for  my  Pixelsign. When I  try  to  use model export Nutcracker freezes. If use the plain export and export as a LCB file it  works but  when I  try to paste to  my LOR  sequence I get this  result:
The words should   not me  flipped.....

[attachment deleted by admin]

Title: Re: LOR Clipboard
Post by: sean on September 09, 2014, 05:08:16 PM

how did youy create modeL? paste xlights_rgbeffects.xml so we can see how you built it.
did you drive the lights from xlights?

how did you create the SETUP tab. paste xlights_networks.xml here or paste a screen shot.

Title: Re: LOR Clipboard
Post by: JonB256 on September 09, 2014, 07:21:29 PM

If your model is defined to have "2 strands per string" then you will get the inverted/upside down text when pasted. It will alternate right side up and upside down, because your strand of lights is doing that.

Title: Re: LOR Clipboard
Post by: zanclus on September 10, 2014, 07:58:26 AM

All is  ok. I ran the  file in LOR and  the  sign  works   just fine. I forgot that I ran  my   nodes in a  zig zag  on the  sign so  when I   make  my  model I  set it  up   that  way. Thanks for the  replies everyone