Sean Meighan

Software => Bugs in xLights/Nutcracker => Topic started by: Drewfus on September 30, 2016, 03:08:56 AM

Title: Not rendering??
Post by: Drewfus on September 30, 2016, 03:08:56 AM

So I was running .49 and it still does it in .50 i load in a sequence i did back in July since i have moved props and added new. i have saved and hit the render all button several times when i play the sequence it does not show me the correct effect but when i click on the effect it does show me the correct one. if i highlight just a section of the sequence it will play the correct effects also just not when i click and start. any ideas?

Title: Re: Not rendering??
Post by: keithsw1111 on September 30, 2016, 04:11:13 AM

Run check sequence and check any errors or warnings.

Title: Re: Not rendering??
Post by: Drewfus on September 30, 2016, 05:26:38 AM

That is a very useful tool thanks I had the model in a group and it was overriding what I had on the model I guess groups take precedent over the model? 


Sent from my iPhone using Tapatalk

Title: Re: Not rendering??
Post by: sean on September 30, 2016, 07:12:06 AM

It depends where the show up in sequencer tab in masterview.  We render models and groups top to bottom. Normally u arrange the groups above the models. I would also suggest your whole house model is first


Sent from my iPhone using Tapatalk

Title: Re: Not rendering??
Post by: Drewfus on September 30, 2016, 07:55:49 AM

Thanks again I guess I have ALOT of learning to do still moving the whole house model to the top fixed it


Sent from my iPhone using Tapatalk