Sean Meighan

Welcome => Do You Need Help? Post it here => Topic started by: bhagan77 on October 22, 2016, 10:18:44 AM

Title: Effects - ESEQ
Post by: bhagan77 on October 22, 2016, 10:18:44 AM

Hey all,

I have figured out how to export my TUNE To sign as an ESEQ so it runs through the night without going on and off between each sequence, and I also like it to be on 10 mins or so before show and after for some announcements etc. but am getting confused on how to call it up.

I have created an event with the effect in there, and then get lost from there.  I figured I'd make a playlist / schedule and call up a "Tune To" playlist at the same time as my "Show" playlist.  That doesn't seem to work as it can't call 2 playlists at the same time I guess.

Is what I am trying to do possible?

Thank you

Title: Re: Effects - ESEQ
Post by: bhagan77 on October 22, 2016, 11:10:23 AM

Figured it out, can close or keep open if others need help.

Have to create the event, and then add it to an existing playlist.  And for the before and after just need different scheduler entries that dont overlap :-)

Title: Re: Effects - ESEQ
Post by: Josh on December 03, 2016, 03:05:53 PM

I could use some help on how to run a Tune To sign separate from my sequences so the tune to sign doesn't go off and on at the end and beginning of the sequences.  My show is ran with the Pi currently.  Any help is appreciated. 

Title: Re: Effects - ESEQ
Post by: Gilrock on December 03, 2016, 04:10:04 PM

Does the Tune To sign have it's own FPP?  I just run mine in Standalone mode with it's own schedule and it just plays my Frequency sequence in a loop.