Sean Meighan

Welcome => Do You Need Help? Post it here => Topic started by: Dave Nibeck on October 25, 2016, 12:52:16 PM

Title: P10 - so close
Post by: Dave Nibeck on October 25, 2016, 12:52:16 PM

Panel (2X3) tests ... something just not right.  See the ripple and marque effects.  I think I have it set up correctly but clearly I don't....

https://www.youtube.com/watch?v=KIj0pQiWzcs (https://www.youtube.com/watch?v=KIj0pQiWzcs)

Title: Re: P10 - so close
Post by: rando1957 on October 25, 2016, 05:05:20 PM

Dave - what does your LED Panels tab look like in the Falcon setup?  I had to play with my layout there to get my arrows facing right direction.

Title: Re: P10 - so close
Post by: Dave Nibeck on October 25, 2016, 05:42:08 PM

I think I have it right...

Title: Re: P10 - so close
Post by: rando1957 on October 25, 2016, 06:03:40 PM

My start channel on the LED Panel screen is the same start channel as in XL and is the same on the FPP Universe screen as well.  In the Falcon setup you have channel 1 start but in XL you have 1038 (?? can't remember). Wonder if that is your problem?

Title: Re: P10 - so close
Post by: CaptainMurdoch on October 25, 2016, 10:20:28 PM

Check the solder joints on your Octoscroller.  This looks like it might be an issue with one of the three address lines that select the row of the park that data is being sent to.  All outputs share the same address lines so it would affect all 3 outputs you are using.

Title: Re: P10 - so close
Post by: Dave Nibeck on October 26, 2016, 01:56:02 PM

Thanks.  I don't see anything obvious but I'm not really sure I could tell unless is was really obvious.  I'll check with Todd at DIY to see if he will send a replacement.