Sean Meighan
Software => Xlights Setup => Topic started by: theycalmegriswald on November 25, 2016, 07:00:39 PM
-
When I play the songs (output to lights) each song plays fine individually. When I turn on my scheduler, one whole controller doesn't work. I have rendered all, saved each file several times, even deleted the playlist and schedule an built a new one, same thing. I have looked at all my channels, programming sequencing and ran a test in test mode, everything is great until I click on run schedule.
Any ideas would be great. Thank you
-
All
I really could use some ideas on this. I have gone through everything several times and it is not adding up. Songs and display work perfect when played individually. When I run schedule one whole controller (controllers 10 trees) doesn't come on. Time to run the show and until I can get this figured out, I can't. Please help! Thanks.
-
I'd help if I knew anything. I don't know anything about the xLights scheduler. I have seen more people post issues with it than most years. I have to assume someone made a change that broke something because it has always been considered rock solid. Most of us use an FPP so we don't know much about the xLights scheduler to offer any help.
-
I just ordered a pi and will be going to FPP hopefully next week. Really makes no sense. You know of any issues with windows 10? It seems as if xlights acts up once in a while. Sometimes I have to render a song right after opening it before it works correctly in sequence tab. Other times it works fine. Not sure if it is a software issue on xlights with windows 10 or windows 10 itself.
-
How do you have the controllers hooked up? are you using a bridge? I have never had any problems when using the scheduler
-
Going first to the e1.31 then coming off of two of the RS output to two dumb rgb controllers.