Sean Meighan

Software => Nutcracker Effects => Topic started by: JasonPortwood on December 04, 2016, 08:15:05 PM

Title: vu meter not going across a hole element
Post by: JasonPortwood on December 04, 2016, 08:15:05 PM
I am trying to use a VU meter effect on my display.  I have 5 columns (18 pixels long each) but when I use VU meter across the group I only get the first 4 columns.  Is there a way to get that to all 5 and get that varying up and down effect?  Or do I need to use a glediator file created in Jinx to get the desired effect?

Thanks for any advice.

Jason
Title: Re: vu meter not going across a hole element
Post by: keithsw1111 on December 04, 2016, 08:17:28 PM
Which vu meter effect. There are several. Have you played with the bars setting. Setting it to a value that is a multiple of the model width helps. Because it is a group the width is likely 400.
Title: Re: vu meter not going across a hole element
Post by: JasonPortwood on December 05, 2016, 09:49:16 AM
I think I worked it out I think.  It was just a group of 5 strings so I put them in a matrix and then I had all five in use.

I just have to work out the up/down of my matrix with the strings.  I'll probably just make a custom model since it's so small if I can't work out my string direction.  Haven't done a matrix before so I probably just need to look a little harder at the settings.

Thank you,

jason