Sean Meighan

Software => Bugs in xLights/Nutcracker => Topic started by: Ebuechner on March 18, 2017, 12:04:14 PM

Title: Data layers
Post by: Ebuechner on March 18, 2017, 12:04:14 PM

I went back into one of my old sequences with 2017 .6 and after I hit render all my data layer was off buy one channel starting from the first channel. I went back and tested where the break was and it looks like it's between 2017.2 and .3

Title: Re: Data layers
Post by: Gilrock on March 18, 2017, 12:13:41 PM

I really don't want to try to figure out why.  Just use the Channel Offset feature in the Data Layer settings.

Title: Re: Data layers
Post by: Ebuechner on March 18, 2017, 12:26:57 PM

Will it accept -1 without creating an issue?

Title: Re: Data layers
Post by: Gilrock on March 18, 2017, 12:38:02 PM

Sorry but I get offended when someone wastes my time with a question that they could have answered by just trying what they are asking.

Title: Re: Data layers
Post by: Ebuechner on March 18, 2017, 01:54:46 PM

Sorry that you're offended but I wasn't sure entering a negative value would cause an issue. I did try it and it works but I asked the question in case it will cause a negative reaction somewhere else and i have to trace it back. (Ounce of prevention)

Title: Re: Data layers
Post by: keithsw1111 on March 18, 2017, 02:39:35 PM

I will look at this when I get a chance.

Title: Re: Data layers
Post by: Ebuechner on March 18, 2017, 02:55:32 PM

If it helps at all I went back and installed older versions going forward till I could reproduce the problem. Let me know if you need any files from me to help you reproduce what I'm seeing

Title: Re: Data layers
Post by: JonB256 on March 20, 2017, 08:29:59 AM

I use an offset of -1024 (two universes) for some of my very old LOR sequences. Its easier than re-doing the sequences.