Sean Meighan

Software => Xlights Setup => Topic started by: ranjanpa on October 27, 2014, 08:48:32 AM

Title: No able to play from NC
Post by: ranjanpa on October 27, 2014, 08:48:32 AM

I have a combination of LOR, Dumb RGB and e 682.

NC is not able to play the final fseq file. I can see it in preview but it will not output to light.

I tried with LOR connection removed but still get the error as attached.

Pls advice.

I did shutdown LOR and rebooted my computer too. Still does not output to lights.

[attachment deleted by admin]

Title: Re: No able to play from NC
Post by: flyinverted on October 27, 2014, 05:24:34 PM

Have you set  your LOR controller to DMX mode via the control pane or dip switches?

Title: Re: No able to play from NC
Post by: ranjanpa on October 27, 2014, 07:40:19 PM

Hi,

I was able to sort this out.

NC expects all the ports to be occupied as per the set up defined. So in my case I had to connect LOR, X Dongle for dumb RGB and Cat 5 for e 632 all together.

Moreover the COM port in which I was attaching the X Dongle was actually COM4. I was assuming this was COM2.

Took a long time to trouble shoot but over it now.

Now I am trying to attach an audio file for the xseq sequence.

Regards.