Sean Meighan

Software => Bugs in xLights/Nutcracker => Topic started by: rando1957 on February 19, 2018, 03:11:46 PM

Title: Value Curve Changes
Post by: rando1957 on February 19, 2018, 03:11:46 PM

Noticed this when using 2018.4 and 2018.5; not in 2018.3 nor what I used in 2017

In the 'ON' effect, had simple fade down (100 to 50); the value curve shows saw tooth, but I did not want it or use it. In v.3, the effect works as I wanted it - just fade down. In v.4 and v.5, the saw tooth value curve started taking effect and my fade down was going multiple times.
Was this a fix in v.4?  If so, then I will go through my sequence and remove that value curve. Just wanted to know if this was a fix or a bug introduced in v.4.

Title: Re: Value Curve Changes
Post by: Gilrock on February 19, 2018, 07:52:12 PM

I don't see Value Curves on the On effect except in the Transparency field so can you clarify what curve you are talking about?

Title: Re: Value Curve Changes
Post by: rando1957 on February 20, 2018, 07:26:59 AM

Yes Gil, it is on the Transparency row and Transparency is set to 0; For some reason it is showing Saw Tooth value curve and when I select the effect in the sequence grid, the effect starts ramping up and down repeatedly.  I didn't change this from earlier versions.

Title: Re: Value Curve Changes
Post by: Gilrock on February 20, 2018, 08:13:44 AM

I don't know of any specific change that "fixed" this but it sounds like you had a value curve defined all along that wasn't working and now it's working so I can't call that a bug.