Sean Meighan

Software => LOR => Topic started by: flyinverted on November 16, 2014, 10:46:20 PM

Title: LOR CCR cabling to DMX
Post by: flyinverted on November 16, 2014, 10:46:20 PM
To get a CCR to work with DMX, cut the end off a Cat 5 cable and wire the other end as follows.


Brown=    Ground
Blue =      DATA +
Blue/Wt = Data -

This is NOT the wiring I'm using for an LOR CMD24, but this is working just fine with a CCR controller connected to a SanDevice E682.   

I hope this helps those trying to sort this one!
Title: Re: LOR CCR cabling to DMX
Post by: bobbert on November 19, 2014, 08:12:36 AM
What color wire goes in which position?
Title: Re: LOR CCR cabling to DMX
Post by: flyinverted on November 19, 2014, 10:34:03 AM
It depends on the connector/controller being used

An XLR connector as well as an E682 4 pin Euro connector will be

Brown      Pin 1 Ground
Blue/Wht Pin 2 Data -
Blue         Pin 3 Data +


Don't forget that on the E682, you must configure DMX output via Jumper 22 AND the software config.
All other lighting types are configured via the software config only.