Sean Meighan

Software => Bugs in xLights/Nutcracker => Topic started by: taintedsaint on August 08, 2018, 06:53:35 PM

Title: Colors in sequence different at pixel
Post by: taintedsaint on August 08, 2018, 06:53:35 PM

After overcoming an earlier overpower issue, the second problem persists. Literally NO color selected in sequence displays correctly at pixel. TEST of each model cycles through correctly however one set of small led boxes are sequenced Yellow but display a light purple. Two larger elements are sequenced in a string of on/off/on/off red and are displaying green.
Again, when I run a TEST of any element I'm getting good RGB cycles. Just as a test I set 'output to lights' and clicked on the above referenced Yellow and could adjust HUE to get close but not yellow.
Can't figure what is up.
The boxes mentioned are 2811 strips, the other elements are 2811 bullets.
Any guidance is appreciated.

Title: Re: Colors in sequence different at pixel
Post by: QldKing on August 08, 2018, 07:43:58 PM

Do you have the lights set to the correct format in the layout tab (BRG, GBR, RBG etc)?

Title: Re: Colors in sequence different at pixel
Post by: taintedsaint on August 09, 2018, 05:24:38 AM

Yep,thats the first thing I checked.

Title: Re: Colors in sequence different at pixel
Post by: Anthony.Bigda on August 09, 2018, 06:15:17 AM

Did you double check your channels? I had this happen a few weeks back and I have put the starting channel 1 number off and it had the entire string displaying incorrect colors


Sent from my iPhone using Tapatalk