Sean Meighan

Software => Xlights Setup => Topic started by: MarkMitchell on November 07, 2018, 11:12:14 AM

Title: Channel Mismatch
Post by: MarkMitchell on November 07, 2018, 11:12:14 AM

I have my whole house outlined with Holiday Coro Brilliant bulbs.  Most of the strings run perfectly, however, on just two of the strings, the last bulb on the string will not properly render the blue color (the last channel).  When I put the controller in test mode, the bulbs all show up perfectly.  The only way I can get it to work from xLights is to tell the model that there's one bulb more than there really is. 

None of my outputs have too many pixels, so it's not that.

Any suggestions would be greatly appreciated.

Title: Re: Channel Mismatch
Post by: keithsw1111 on November 07, 2018, 11:32:39 AM

Sounds to me like you have an off by one channel configuration error.


Sent from my iPhone using Tapatalk