Sean Meighan

Software => Xlights Setup => Topic started by: Brightlights on November 13, 2018, 06:01:00 PM

Title: Layout setup with Mini trees using LOR AC controller
Post by: Brightlights on November 13, 2018, 06:01:00 PM

I am using LOR controller for the mini tree. When I layout a mini tree to look like a tree, # Strings 5, to look like a tree and then setup the DMX channel for the LOR controller, in this case unit 3, LOR= DMX 33 the end channel is 37 because of the 5 strings. How do I assign 1 channel, start and end channel to be the same and have the model look like a mini tree not a stick tree like the Charlie Brown tree? This is causing overlays. Attached is a picture of the mini trees. I am going to use a Falcon controller for my DMX Bridge.

Title: Re: Layout setup with Mini trees using LOR AC controller
Post by: keithsw1111 on November 13, 2018, 06:10:57 PM

1 string. 50 nodes per string. 5 strands per string.


Sent from my iPhone using Tapatalk

Title: Re: Layout setup with Mini trees using LOR AC controller
Post by: Brightlights on November 13, 2018, 09:36:39 PM

Quote from: keithsw1111 on November 13, 2018, 06:10:57 PM

1 string. 50 nodes per string. 5 strands per string.

Thanks Keith, that is what I was looking for.

Title: Re: Layout setup with Mini trees using LOR AC controller
Post by: keithsw1111 on November 14, 2018, 01:19:57 AM

http://videos.xlights.org/xlights-primer-on-defining-tree-models_8caf23d94.html


Sent from my iPhone using Tapatalk