Sean Meighan

Welcome => Do You Need Help? Post it here => Topic started by: buffalobob on December 17, 2018, 04:06:36 PM

Title: House Verticals
Post by: buffalobob on December 17, 2018, 04:06:36 PM

Hello

I have a three sets of lights that are setup as single line models wired in series. My one set in Xlights are setup to follow the previous one so for example, my house 1 is setup on universe 23:1 with house 2 setup to follow house 1, house 3 to follow house 2 and so on. The channel numbers do follow each other in order. They are 24 nodes each and I have the string properties set for 96 lights (4x24).  When I test them, only the first set lights up.

One of my sets are setup the same way and works just fine.

Not sure what I am doing different.

Any suggestions will be helpful

Title: Re: House Verticals
Post by: Gilrock on December 17, 2018, 06:58:04 PM

Show screenshots of all setup in xLights and the controller.

Title: Re: House Verticals
Post by: buffalobob on December 18, 2018, 12:16:34 PM

Attached are the screen shots of my House Verticals that I can't get to work. I can only get the first set to work.

Let me know what you think and thanks in advance

Title: Re: House Verticals
Post by: Gilrock on December 18, 2018, 12:28:00 PM

You didn't show the xLights Setup tab.  I assume you have enough channels allocated for universe 23....at least 288.  How are you testing?  If it were me I'd forget the test tab.  Just create a new animation sequence and then start dropping Butterfly effects on each model.

Title: Re: House Verticals
Post by: buffalobob on December 18, 2018, 02:16:19 PM

Here is my setup tab.

When I run the sequence only one set lights up.,

Let me know what you think. ,

Title: Re: House Verticals
Post by: Gilrock on December 18, 2018, 04:59:01 PM

I don't see anything wrong.  Only other thing we should look at is the E131 Configuration page on the Falcon.