Sean Meighan

General => The Water Cooler => Topic started by: mmais on February 19, 2019, 05:06:23 PM

Title: Sequence Error Problem
Post by: mmais on February 19, 2019, 05:06:23 PM

I checked my sequence today & received an error, says I have an overlap.
I know I am going to get chastised for the way I have everything set up.
First attachment below is what the error is.
next two are the 2 Pixel trees that are involved & the start channels.
 The forth attachment is what my setup is.
 I have looked at this till I am cross eyed & can not find the correction to the error. Maybe someone else can see it.
 Thanks Mike

Title: Re: Sequence Error Problem
Post by: keithsw1111 on February 19, 2019, 05:48:36 PM

Without the # the first number of your start channel is an output number. Not a universe number. Given your 54-55 grouping they are not the same thing.


Sent from my iPhone using Tapatalk

Title: Re: Sequence Error Problem
Post by: mmais on February 19, 2019, 05:54:14 PM

If I understand you correct I need to put a # in front of all the universes?
 Is this something new as I have never done this before & this will be my second year. Ran flawless last year with out the #
Mike

Title: Re: Sequence Error Problem
Post by: keithsw1111 on February 19, 2019, 08:32:51 PM

No it’s not new. It likely worked for you because your universes and output numbers used to match. And now they don’t.


Sent from my iPhone using Tapatalk

Title: Re: Sequence Error Problem
Post by: allknowing2012 on February 20, 2019, 07:07:32 AM

Or you didnt select the Universe portion off the popup screen (and used Output) instead.