Sean Meighan

Software => Bugs in xLights/Nutcracker => Topic started by: charlie-68 on September 19, 2019, 03:24:00 PM

Title: I have a issue
Post by: charlie-68 on September 19, 2019, 03:24:00 PM

I uploaded the last update in which I had to include my E mail address. I do not think I opened xlights after that until today. I cannot get the part of the toolbar to show up that has show directory; open sequence ete to show up. It is grayed out . Hope this will help  Charlie J.

Title: Re: I have a issue
Post by: keithsw1111 on September 19, 2019, 07:10:07 PM

Reset your toolbars.

Title: Re: I have a issue
Post by: charlie-68 on September 20, 2019, 09:03:12 AM

I just reset the tool bars, the icons did not restore. The one section of icons are missing.  Charlie J.

Title: Re: I have a issue
Post by: Gilrock on September 20, 2019, 01:25:12 PM

So they were greyed out and now they are missing?  If you can't find where the toolbar was dragged to then you might need to start the program from the command line with the switch that resets the registry.  I don't know the command cause I've never needed it.

Title: Re: I have a issue
Post by: keithsw1111 on September 20, 2019, 09:33:09 PM

/w resets xLights to the first run state.

Title: Re: I have a issue
Post by: charlie-68 on September 21, 2019, 11:07:10 AM

I'm not sure what happened but I closed xlights as I normally do. It was off for two days, I started it today and the all the icons are there. When I first noticed the problem I shut down the program and restarted it to no help. Now all is back to normal.  Thanks  Charlie J.