Sean Meighan
Software => General Software => Topic started by: NTJP on September 26, 2019, 10:15:45 AM
-
I am sure this has been asked and I have been reading. New to all pixels. I have 2 mini trees, each 50 pixels. 10 tall by 5. I am connecting them by 5 foot extension cable. They will run from 1 channel as 100 nodes. How do I connect them in the layout so they run on one channel? There is no drawing for an extension cord. It may help to know I am running them from a LOR Pixcon16. This will also help as I am planning on 2 channels of 4 mini trees 5 tall by 5 wide running as 100 nodes each for the sidewalk on a F48.
-
If 2 models are on the same channel just type in the same start channel for both of them.
-
Last year I had a mega tree and this year is all pixel. Being new, a lot of the questions I ask may not be clear and understanding answers difficult. The above answer is a good answer but, I did not understand how to make it happen. For those in the future looking at this post for an answer I found the below video to be very helpful. There are other videos also which you can search and find on xlights at http://videos.xlights.org/.
For those new this will be a go to for answers to a lot of your questions. Also can learn a lot about things you had not thought to ask by scrolling the videos.
Good luck and enjoy. It is an expensive hobby but most hobbies are and this gives you a reward of happiness for yourself and most importantly others.
http://videos.xlights.org/xlights-4-webinar-series-controller-setup-and-channel-mapping_6a31ce80c.html