Sean Meighan
Welcome => Do You Need Help? Post it here => Topic started by: jmhabermn on October 12, 2019, 05:51:19 PM
-
I am able to run a sequence directly from XLights and it is able to control my LOR controllers through a LOR network using a LOR dongle. When I run the sequence from xSchedule the LOR controllers will only work when I start and stop the sequence 3 times. This the only sequence in this playlist. I tried deleting the playlist and recreating it. There are no issues identified in check sequence for both XLights and Xschedule. Both XLights and Xschedule are using the same show directory. I am curently running 6 Falcon controllers using ZCPP, 1 LOR network (from dongle) and 1 DMX network (from dongle).
I'm working to move the LOR and DMX network to the serial output ports on the Falcon controllers but I have an issue with the DMX data being scrambled. It's doing the same thing on 2 controllers. I configured the ports using ZCPP. I'm sending these channels from Xlights but it appears that that the controllers are seeing the following channels:
1 > no output
2 > 1
3 > 2
4 > 3
5 > 4
6 > 5
7 > 6
8 > 13
9 > 14
10 > 15
11 > 10
12 > 11
13 > 12
14 > 7
15 > 8
Any suggestions? Thanks
-
Try .57. There are some serial/zcpp fixes in this release.
When xschedule drops the connection. Do you have logs.
There is no obvious reason why it would work differently to xlights.
-
The problem with the serial output ports is resolved. Please note that after I loaded .57 I had to put the controller in E131 mode, change the serial output start address from 2 to 1 and put it back into ZCPP mode to get it to work. Thanks
-
Version 2019.58 is already out...you're behind. :)