Sean Meighan

Software => Xlights Test => Topic started by: ericg2000 on November 18, 2019, 09:09:53 AM

Title: String not fully lighting up
Post by: ericg2000 on November 18, 2019, 09:09:53 AM

I have a string of 112 C9 pixels from holidaycoro (50+50+12).  When I run my sequence the string will not light up. If  take the 12 off the other 100 will light normal. If I take the 100 out the 12 will light normal.  I have the model defined as 1 string 112 pixels. Will these not work if over 100 pixels?

Title: Re: String not fully lighting up
Post by: Gilrock on November 18, 2019, 09:39:42 AM

Its the setup in the controller that would define how many pixels its driving.

Title: Re: String not fully lighting up
Post by: ericg2000 on November 18, 2019, 04:20:23 PM

I have the pixel count set to 112 in the output settings.

I sent a message to holidaycoro but haven't heard back yet

Title: Re: String not fully lighting up
Post by: Gilrock on November 18, 2019, 08:07:43 PM

Have you tried swapping the 50 count strings?  Maybe the output of the last pixel or wiring is messed up so it can't drive the next string.  If so swapping the 50's should make only 50 work.

Title: Re: String not fully lighting up
Post by: ericg2000 on November 21, 2019, 06:06:46 AM

it's not an easy swap... they are on a 30' peak on my house.  i tested the lights before i had they hung and they worked... but i tested the strings individually not connected together.  i have another string i am going to connect to the other end and if it works i will have the guys come back and rehang them.