Sean Meighan

General => The Water Cooler => Topic started by: NTJP on February 22, 2020, 12:35:52 PM

Title: 12 volt Light question
Post by: NTJP on February 22, 2020, 12:35:52 PM
Have a couple of 12 volt flood lights that are not rgb.  Just a standard 12 volt plug into cigarette lighter.  Was thinking of using them for lighting effect Halloween.  Is there a way to turn them on and off with XLights?  Did not know how to wire it.  Or do I need to buy a special controller to make them work?  May not be worth it if have to buy controller. Nodes are wired with 3 wires, positive, negative and data.  I figure if I wire the positive and negative to the lights they will been on continuously.  Do not think wiring negative and data would work either.  Anyone done this before?