Sean Meighan
Software => Xlights Test => Topic started by: charlie-68 on March 03, 2020, 08:05:23 AM
-
I've done the last update, did some changes in my setup so I have no unmanaged lines. Have my small matrix connected for test (12 by 36 nodes) and a 50 node star, Test with my Falcon f 48 and the outputs look good. Test with xlights all outputs look good. The problem when I test with only the 4 outputs for the matrix and star ,which is 13, 14; 15; 16 the lights do NOT light. I've gone back and redid all my tests with the same results. But my sequence appears to play as expected! Is there a glitch in the test page?
-
Some additional info. On the controller page to channels is set for 512. When I go to the test tab and select channels it shows all channels, so what I expect on a channel is not there because all 512 channels is shown for each line. When I go to the model tab and test the model/prop, it lights as expected, because it is going to the prop only. Thus when I select the absolute number range for the prop, the prop lights even though it is the incorrect line/universe number. I hope this makes sense. I need more time to explore the new update. I think I'm getting it. Charlie J.
-
There is not enough information here for us to look at anything.