Sean Meighan
Software => Xlights Setup => Topic started by: djmc2002 on June 08, 2020, 08:28:30 PM
-
Hello, quick question about the controllers set up page. I have 2 p10 screens that run off a BBB with at cape (dont remember who made the cape) The BBB is running Dan Kulp FPP. My question is this on the xLights controller set up page for "Vendor" do I select "FPP" and for the model "LED Panels" ?
Also what about auto upload, auto size? Checked or unchecked? Anything else with the visualiser page, or other tricks or tips?
Thanks
-
I have a 2 x 2 P10 panel matrix and it is set up like you noted. Vendor is FPP and model is LED Panels. I am running with a BBB in bridge mode with an octoscrolla attached. I am running 2 panels off each output 1 and 2. The data is coming from a PI3b through ubiquiti wireless on multicast. It all works very well.