Sean Meighan
Software => General Software => Topic started by: charlie-68 on October 19, 2020, 08:07:10 AM
-
In the 2020.42 release notes there is s note about the star, it was about the drop down for the start location. My star is not working as expected. My star is a 90 pixel with 3 layers,20;30;40. The effects does not look correct. I went to the strands and the 20 , inner is showing on the outside with the rest out from there. I have looked at the wiring diagram , bottom center cw, is my prop wiring. I rendered the effect 3-4 times. no change. What am I doing wrong?
-
I'm updating my info. The problem with the effects was linked to a need to update the Falcon uploads and down loads. Effects appear OK. But I still see a problem in the strands of the model. When I select the star and go to the strands; the inside strand is on the outer layer with only 20 pixels on, then middle strand lights up the next 30 middle layer, outer layer (40) lights the remaining.
-
I think Scott fixed this for .44
-
I up dated yesterday and it did not fix the problem.
-
Charlie - did you reenter the values of the layer with smallest to largest?
-
Ed posted files to github and now I think I have it fixed. It looks like it was broken where you were using strange and had it wired from the centre.
-
Thanks, the last update fixed the problem. The lights was wired according to xlights wiring diagrams. Again thanks Charlie J.