Sean Meighan

Software => LOR => Topic started by: PyroVice on November 14, 2020, 05:05:07 PM

Title: No comm Lor
Post by: PyroVice on November 14, 2020, 05:05:07 PM

Hi, after days of pulling hair out.. I Just switched to xlights from lor. Mapped everything over. Its a small show with 4 lor ac controllers and a pixcon 16. So went into  xlights /controllers  clicked discover, it finds the pixcon 16 little light bottom corner is green everything is great. added the lor controllers in usb dongle connection. that is green good to go. Go to control lights in xlights and nothing. either controllers work. the lor ac and the pixcon 16 still have flashing red lights. I tryed everything. I went back to lor network  and can control pixcon 16. And then went into lor  hardware and can control ac controllers. Can connect in xlights  Any ideas? thanks in advance.

Title: Re: No comm Lor
Post by: PyroVice on November 14, 2020, 05:27:29 PM

Also I tryed to upload output.. And I get a message LOR output upload Failed. Unable to connect.

Title: Re: No comm Lor
Post by: keithsw1111 on November 15, 2020, 10:31:51 AM

I would jump into zoom or start by sharing your controller tab config and controller config a.

Title: Re: No comm Lor
Post by: PyroVice on November 15, 2020, 12:30:46 PM

I hope this is what u asked for. this is just the pixcon 16 controller.  directly connected to back of pc. thank you.