Sean Meighan

Welcome => Do You Need Help? Post it here => Topic started by: konzalchristmas on November 18, 2020, 10:34:25 AM

Title: Model Issues
Post by: konzalchristmas on November 18, 2020, 10:34:25 AM

I am new to xLights and cannot figure out why my Mega Trees with 16 strings with 100 pixels (50 up, 50 down) only shows an effect on the first 16 strands. I have checked my model setup - 360 degrees, 16 strings by 2 strands. Starting channel is IP, universe, channel 1; starting location bottom left. I do not have individual start channels.

When I test the Mega Tree out of xLights, there are no issues. Not sure where to go from here. Does anyone have any recommendations?

Title: Re: Model Issues
Post by: keithsw1111 on November 18, 2020, 12:27:31 PM

Have you run check sequence. I can think of a number of things that could be wrong but there is not enough information here to narrow it down.

Title: Re: Model Issues
Post by: konzalchristmas on November 18, 2020, 06:28:59 PM

Thanks for your feedback! I was able to figure it out, it had to do with assigning individual start channels to my mega tree. It works now.