Sean Meighan
Welcome => Do You Need Help? Post it here => Topic started by: JEBariffic on November 21, 2020, 03:08:29 PM
-
Greetings!
I've got a Macbook Pro running xLights and scheduler, its directly connected to falcon board V3.
I've no problem testing sequence in xLights. I can not seem to get xscheduler to pass data to the flacon however. Strangely, the bottom of the scheduler interface shows IP 0.0.0.0, and when I run the diagnostic within scheduler, it says its trying to broadcast to 0.0.0.0 which obviously wont reach the falcon.
My mac is on IP 192.168.15.100 and falcon is on 192.168.15.105, both on sub 255.255.255.0.
For the life of me I can't figure this out. Frustratingly, this setup worked wonderfully last year. Greatly appreciate any suggestions as my show is dead in the water. :-(
-
I had the same issue and resolved it by getting a previous version of xLights and downloading that to my MAC. Luckily I had it in my downloads, cannot figure out how to get previous versions from the Apple store. Put my copy in the attachments. Maybe that will work.