Sean Meighan

Welcome => Do You Need Help? Post it here => Topic started by: kiefferr on September 29, 2021, 07:09:58 PM

Title: First try at this....need some help
Post by: kiefferr on September 29, 2021, 07:09:58 PM
Hello all!  I'm very new to programmable lights.  I've tried searching but can't find what I'm having trouble with...

Fairly simple setup...2 WLED controllers, 1 driving 150 RGB pixels, the other driving 250 RGB pixels.

I've got the controller for the 150 string set with one universe, and the other set with two (starting universe 2, so it uses 2 and 3).

In the layout tab, the "garage" string starts at #2:1, ends at #3:240 and the "roof" string starts at #1:1 and goes to #1:450.

When I use the TEST tool in XLights (and when I send my sequence to them), the first pixel in universe 3 doesn't light.  WLED will make all pixels light/respond to commands/etc, so I know that they are all working. 

I'm sure it's something I've messed up in the xlights config.  Any help would be greatly appreciated.
Title: Re: First try at this....need some help
Post by: Gilrock on September 30, 2021, 10:31:37 AM
Sounds like a mismatch between the xlights setup and the controller setup as to how many channels there are in each universe.  Not sure if you are using 510 or 511 but it needs to match on both sides.
Title: Re: First try at this....need some help
Post by: kiefferr on September 30, 2021, 04:12:21 PM
Attached some screen grabs of my xlights setup.  Let me know if more is needed...
Title: Re: First try at this....need some help
Post by: kiefferr on October 02, 2021, 11:03:34 AM
Got it sorted.....turns out it wasn't xlights, but WLED that was causing the problem (but only when using E1.31...they were fine in WLED directly).  Updated to the latest WLED firmware, all is good.