Sean Meighan

Welcome => Do You Need Help? Post it here => Topic started by: marksat on November 25, 2021, 05:28:02 PM

Title: Mega Tree - Programatically Move/Rotate Center
Post by: marksat on November 25, 2021, 05:28:02 PM

Ok - I put up the megatree, but the center/start point is not where I meant to put it (e.g. string 1 should be pointing due South, but is off a bit).

Is there a way to adjust the model output in XLights (instead of physically re-positioning the strands of the tree, or adjusting every sequence)?

I tried adjusting the RotateY attribute on the Layout tab, Size/Location area but that does not seem to do anything.

Thank you in advance.

Title: Re: Mega Tree - Programatically Move/Rotate Center
Post by: Bill - PVL on December 12, 2021, 01:04:03 PM

I have this same question.   I would like to turn it about 25 degrees and can't figure out a way to do it.  Did you get an answer?

Title: Re: Mega Tree - Programatically Move/Rotate Center
Post by: K-State Fan on December 12, 2021, 03:01:08 PM

Set the rotation to what you want it to be on the model setup