Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - preston meyer

Pages: [1]
1
Do You Need Help? Post it here / Re: Not quite getting thew PolyLine tool.
« on: November 15, 2016, 11:37:08 AM »
Escape key is fine!!!

Was placing start point on left and placing more points toward right. Did this several times with same result, only way to stop it was to shut down xlights.

Read in another post, that I accidently came across, that there is a problem with "green" and "blue" points with the green needing to be on the right.

Tried polyline again by starting on the right and going left, which then allowed stopped point placement with the ESC button.

Once that was triggered one time, I can now place points in any direction and ESC works as advertised.

Hopefully this may help.

2
Do You Need Help? Post it here / Re: Not quite getting thew PolyLine tool.
« on: November 15, 2016, 10:24:31 AM »
Running .51 and have same problem, can't get poly line to stop placing more line locations. ESC does not work.
????

3
xLights Convert / Re: LOR sequences using CCR's....
« on: January 28, 2014, 01:38:24 PM »
I have a LOR sequence (for a Ouija board prop) that runs one 16 channel controller, and a 8 channel "servo dog" controller. Can also be with or without a CCR. Do you still need copies? Preston

4
Nutcracker Models / Exporting models to LOR visualizer
« on: January 14, 2014, 05:32:37 PM »
Can a model as shown in xlights Preview or Nutcracker screens be imported into the LOR Visualizer? As far as I can research there is no way in LOR to create a pixel matrix of any shape other than manually creating each individual pixel location and channel assignment.

Pages: [1]