Messages

1

Nutcracker Models / Re: Whole House Model - different colors!

« on: December 04, 2014, 02:51:05 PM »

I just ran into this issue after finally getting set up last night.  I set each model to adjust for the strings out off order, but the whole house model is straights RGB.  Sean, will this be fixed our is it a cost of doing the model as one straight element?  I was hoping the model generator would use the order from each set string.  I have controllers in hard to reach places, and honestly didn't know they were different until testing.
Edit: I can fix the lower ones, I was off by one channel on my roofline for the first set, that hurt me a lot over 11 sets. I can fix this yet.

2

Xlights Test / Re: Help with E1.31

« on: November 29, 2014, 11:49:42 AM »

I completely uninstalled and reinstalled, all is well now.  I can't figure out why, but as long as it's working who cares.

3

Xlights Test / Re: Help with E1.31

« on: November 29, 2014, 07:29:13 AM »

My controllers work.  SacnView confirms that.  My setup is just 8 universes of E1.31 output.  Hard to post from my phone.  I just click add E1.31, starting universe 1 total of 8.   

4

Xlights Test / Help with E1.31

« on: November 28, 2014, 09:41:35 PM »

I have not been able to get Xlights to output anything past universe 3.  My hardware is fine, SACN view works great.  I deleted all my models, deleted all my config setup, tried over and over. Just downloaded the latest release as well.  Am I crazy?  Help!!!