1
Enhancement Requests / Re: Saving models
« on: September 20, 2015, 02:46:47 PM »
Thanks for the quick reply. I didn't realize the Layout Save button also saved the models.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Enhancement Requests / Saving models
« on: September 20, 2015, 02:02:40 PM »
If this functionality already exists, please let me know...
It would be nice if model settings were saved when one clicks the Okay button on the model list dialog. Alternatively, perhaps they could be saved when a sequence is saved. Currently, it appears models are only saved when existing Xlights.
I spent a couple of hours configuring models and channels settings and created a test sequence to verify the layout. I saved the sequence several times so I;d have a version to roll back to if needed.
Unfortunately, my machine crashed (BSOD) near the end of this exercise. Once back up and running, I found the sequence was intact, but I lost all the work I;d done on the models.
Thanks,
pcb
It would be nice if model settings were saved when one clicks the Okay button on the model list dialog. Alternatively, perhaps they could be saved when a sequence is saved. Currently, it appears models are only saved when existing Xlights.
I spent a couple of hours configuring models and channels settings and created a test sequence to verify the layout. I saved the sequence several times so I;d have a version to roll back to if needed.
Unfortunately, my machine crashed (BSOD) near the end of this exercise. Once back up and running, I found the sequence was intact, but I lost all the work I;d done on the models.
Thanks,
pcb
Pages: [1]