Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - packetbob

Pages: [1]
1
Nutcracker Models / DMX Flood Channel Presets?
« on: February 22, 2020, 10:29:59 PM »
I am very new to xLights so may not be searching for the correct terms...
I have some very cheap 8 channel RGBW floods...
I only want to use the RGB channels (5, 6 & 7)...
I can easily just set these up in the xLights model...
But the lights master output is controlled by channel 1 (regardless of what the RGB channels are set for)
Essentially I always want channel 1 to be set for 255 and then just use the RGB channels for control..
I would think (but could easily be wrong) that I should be able to do this in the Model and then the sequencing could just treat the light as easily as a RGB pixel..

Should I be looking at another way to do it?
Thanks

Pages: [1]