Messages

1

Do You Need Help? Post it here / Re: Not Converting to LMS Correctly

« on: September 20, 2015, 11:34:59 AM »

Bingo!  It's been too long since I added a Network.  I do however get 177 additional blank channels in my lms file that are not defined anywhere in my system.

2

Do You Need Help? Post it here / Not Converting to LMS Correctly

« on: September 20, 2015, 08:30:37 AM »

Version 4.2.6
I built a pixel tree a couple years ago, in this upgraded version that still works fine.  However.  I'm adding pixels to my house and that isn't working.
Added all of the Networks.
Added all of the models - not sure how these link to the network setup
Added Display Elements with effects.
Saved all.
Try Convert - Pixel tree always converts, but only a couple of my new models/elements show up.  When looking at the Test tab, again not everything is showing up, just what I'm seeing in the LMS convert - same elements.
Is there a pixel or network limitation?