Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Niceguy

Pages: [1]
1
Xlights Setup / Re: what hardware would I need
« on: November 07, 2015, 08:04:35 PM »
Thanks for the help.

I planning on doing my roofline with the c9s from holiday Coro and maybe outlining my garage doors and maybe something else.
I was going to split my roofline in half (50 pixels each) and my garage would make the third channel.

No music this year, I just want to do some cool effects and loop it a few hours a night.

2
Xlights Setup / Re: what hardware would I need
« on: November 07, 2015, 06:47:16 PM »
thanks for the recommendation. Yes, I know its only 4 channels. I figured that would get be me going then I could add on a falcon 16 next year.

I only picked the Alphapix because I planned on ordering some RBG lights from Holiday Coro anyway. Put ill look into the pixlite.

3
Xlights Setup / Re: what hardware would I need
« on: November 07, 2015, 06:21:31 PM »
looks like I'll have to wait until next year for the falcon board.

Would the Alphapix4 work the same way with a raspberry and FPP?

http://www.holidaycoro.com/AlphaPix-4-V2-RGB-Pixel-Controller-p/722-v2.htm


4
Xlights Setup / Re: what hardware would I need
« on: November 06, 2015, 06:45:24 PM »
Thank you for the help!

5
Xlights Setup / what hardware would I need
« on: November 05, 2015, 07:34:57 PM »
I have been playing with the xlights software for a little bit. I'd like to set up an all pixel show just using xlights/nucracker. (I just have a static display now)

I'd like to be able to program everything, then move the file to an SD card so I don't have to have a computer running the show.
At first I will most likely do just effects without music, but would like to be able to add music later if I choose.

Is this possible with xlights? What hardware would I need besides the pixels and power supplies?

Thanks in advance!

Pages: [1]