Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Cousin Eddie

Pages: [1]
1
Do You Need Help? Post it here / Xlights playlist
« on: November 28, 2015, 07:13:18 PM »
Hoping someone can help. When testing my sequence in xlights. The output onto the display is turning lights on in wrong locations. After I hit the green refresh button the sequence will play correctly.  This is fine.
Now when I schedule a playlist xlights is not refreshing the song and it plays incorrectly. How can I correct this?  Is there a way to have xlights refresh before each song?


Sent from my iPhone using Tapatalk

2
Do You Need Help? Post it here / Re: RGB strand color off
« on: November 28, 2015, 08:19:24 AM »
Thank you.  I created a new model and grouped them together.


Sent from my iPhone using Tapatalk

3
Do You Need Help? Post it here / RGB strand color off
« on: November 23, 2015, 12:33:31 PM »
Trying to see if anyone has a solution. I wrapped my window with 2811 pixel strip  using 4 strands of string. I notice that 3 of the strands are RGB color order and the the last one is GRB.  The four strands are designated to a single output in my controller. When I try to change the color order I can only change all 4 strands. Is there a way in XLights or in my AlphaPix16 controller to change only the 4th strand color order?


Sent from my iPhone using Tapatalk

4
Xlights Setup / Re: Setup tab and adding channels later
« on: November 19, 2015, 12:06:30 PM »
Thank you


Sent from my iPhone using Tapatalk

5
Xlights Setup / Re: Setup tab and adding channels later
« on: November 19, 2015, 09:38:35 AM »
All good things thank you

I seem to be confused now as to what the output is. My understanding was the output from a controller. Could someone clarify the output please.


Sent from my iPhone using Tapatalk

6
Xlights Setup / Re: Setup tab and adding channels later
« on: November 18, 2015, 04:50:25 PM »
Ok thank you...now a new problem...
For some reason I never matched up the outputs they all say 1. When I change them the channels say invalid...any suggestions?


Sent from my iPhone using Tapatalk

7
Xlights Setup / Re: Setup tab and adding channels later
« on: November 18, 2015, 03:43:39 PM »
Jnealand
So that I'm clear you can set up a universe and not use up all the channels...then set up additional universes
Ex U1. Using 240 channels
U2 using 501 channels.
And so on...
My question is if you do that do you need to account for the channels not being used in set up for xlights.

For instance if I used the 240 channels in U1. Would I need account for the 270 remaining channels and have my channel count begin after those 270 for my next model?


Sent from my iPhone using Tapatalk

Pages: [1]