1
Do You Need Help? Post it here / Re: Crash on rendering
« on: November 18, 2017, 06:09:54 PM »
Deleted the star and it rendered no problem. Thanks for the help. Now to figure out how to correctly add the star.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Do You Need Help? Post it here / Re: Crash on rendering
« on: November 18, 2017, 05:50:21 PM »
I have the Holidaycoro triple row concentric star http://www.holidaycoro.com/product-p/124.htm
I never got it set correctly last year but I guess the old program didn't care about it. Let me go delete it and hope for the best.
I never got it set correctly last year but I guess the old program didn't care about it. Let me go delete it and hope for the best.
3
Do You Need Help? Post it here / Crash on rendering
« on: November 18, 2017, 03:36:03 PM »
Hi,
I recently setup xlights on a new PC. My previous sequences load fine but when I try to render them it immediately crashes. I initially installed the 64 bit version but since I was using the 32 bit I back-tracked to that with the same issue. I'm assuming there is some setting I am missing with the new install. Log are attached. Thanks for any assistance.
Mike
I recently setup xlights on a new PC. My previous sequences load fine but when I try to render them it immediately crashes. I initially installed the 64 bit version but since I was using the 32 bit I back-tracked to that with the same issue. I'm assuming there is some setting I am missing with the new install. Log are attached. Thanks for any assistance.
Mike
Pages: [1]