Messages

1

Do You Need Help? Post it here / Re: Is XLights the cause of my problem

« on: May 16, 2017, 06:00:06 PM »

"At least one output could not be started. See log file for details



I have seen this error happen when I have the light bulb activated in sequence editor and then try to test lights
using the test tool. Deactivate light bulb and all is good.

2

Bugs in xLights/Nutcracker / Re: Losing the last channel on props

« on: February 18, 2017, 10:10:25 AM »

The same thing happened to me with 2017-3 release. So it may well be a bug.

I changed all of my model start channels from output start channels to universe start channels.
This seemed to fix the dropped channel.

3

Xlights Setup / Re: Alphapix 16 Network Setup Troubles for Mega Tree

« on: February 14, 2017, 02:53:17 PM »

Go to your xlights setup tab and change each of your 16 outputs to 210 channels.
Then go to the alphapix controller and set your dmx start channels to 1--211--421--631--841--1051
1261---1471---1681---1891---2101---2311---2521---2731---2941---3151 This will make xlights & the alphapix the same as far as channel setup goes.
Render your sequence and retry

4

Bugs in xLights/Nutcracker / Re: Models not aligning as expected.

« on: February 05, 2017, 02:32:23 PM »

Hold down the control key and left click each model you want to align. Then right click align top or bottom.