Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - michealhall

Pages: [1]
1
Once you setup and run a schedule from xlights is there key to break out/stop it? the only way I could get out of it was alt f4 but that kills the whole xlights program, I just wana test the schedule then stop it.

2
Thanks for the feed back, will try out the effect, I am still unsure about the cut and paste answer, all I want to do is cut a effect of the timing mark and paste it into several other timing marks that are a different size and it wont line up to the other timing mark length it just paste the effect the same size as it we cut from it wont automatic change to new timing mark length?

3
Newbie and a few question's on use of xlights

Question1
Is there a key to hold down or something so if I copy an effect and paste it to another timing mark to make it fill the timing mark and not adjust it manually?

Question2
Is there an effect I an use to turn on 1 pixel at a time like a chase but leave the light on as it chases up the sting of lights so at the end of the effect all pixels are turned on?

Pages: [1]