Messages

1

Do You Need Help? Post it here / Re: xLights setup works but only 1 controller outputs from FPP

« on: November 28, 2020, 02:07:01 PM »

Same issue here....looking for answers

2

Do You Need Help? Post it here / Re: lost communication between F16 v2 and Xlights

« on: November 15, 2016, 11:11:30 AM »

here is a couple

3

Do You Need Help? Post it here / Re: lost communication between F16 v2 and Xlights

« on: November 15, 2016, 10:35:46 AM »

Yes.

4

Do You Need Help? Post it here / Re: lost communication between F16 v2 and Xlights

« on: November 14, 2016, 11:07:23 PM »

Followed. and crashed.  I am seeing a trend when I hit "output to lights"...this is 3rd time today. 

5

Do You Need Help? Post it here / lost communication between F16 v2 and Xlights

« on: November 14, 2016, 09:45:59 PM »

I have been testing for a month now..  I decided to move ahead and hang my lights.  i was running fine and then Xlights crashed.  I have rebooted but have not been back up and running yet.  I have been hammering away for 13 hrs now...I downloaded 2016.52...and still nothing.  i have checked ,re checked, re re checked cables.. (I am just using 2 strings while i diagnose the problem.)  They both work.  I can run test patterns from the Falcon but cannot test from lights. 

I and am putting up the white flag and asking for help...

Any assistance will be greatly appreciated..
Thanks

6

Xlights Setup / Re: Multiple strips purchased from holiday coro but nor all same GRB

« on: October 08, 2016, 09:00:13 PM »

Same here.

7

Xlights Setup / .xml

« on: October 07, 2016, 03:53:44 AM »

I have been having a lot of difficulties with Xlights.  Saved sequences would load differently on subsequent boots.  My layout would keep reverting to a previously saved incarnation...etc.  I discovered tonight that the .xml extension is used also by Final Cut Pro, within Logic Pro X on my mac.  I found a ton of my "missing" xlights .xml files there.  Is there a way to prevent the merging of these file types in the future? 

8

LSP / importing data layer from LSP

« on: October 06, 2016, 04:44:28 PM »

I am needing help...PLEASE!! i have had ZERO success at importing an LSP sequence into Xlights.  I have followed all of the LOR to Xlights videos to try to extrapolate what I should be doing with LSP.  I have exported to a conductor file, tried importing a data layer...its just not happening.  Maybe because I am on a Macbook pro?   

I would gladly pay someone for teamview assistance.  I have spent way too much of my way too little time, apparently doing the same thing repeatedly incorrect. 

Thanks

Lashbyrn@yahoo.com