Messages

1

General Software / Re: xlights doesn’t see my lights!

« on: December 29, 2018, 08:50:02 PM »

Recheck the ip address

I did get my lights working using my sons computer. I did notice the Controller is acting up! My computer is messed up! How do you check the IP address? Thanks in advance!


Sent from my iPhone using Tapatalk

2

General Software / Re: xlights doesn’t see my lights!

« on: December 22, 2018, 05:42:25 PM »

I did get my lights to work. But I used my Sons old computer! I think I have a setting wrong on my computer blocking xLights. Any suggestions would be appreciated!
 


Sent from my iPad using Tapatalk

3

General Software / Re: xlights doesn’t see my lights!

« on: December 21, 2018, 07:48:29 PM »

check power supply to alphapix, is it actually on, is ethernet cable plugged into computer and alpha.
Do you have multimeter, check for power & data on each output.
what version of xlights are you running, if you can ping the controller then network should be good.
Have you re-rendered all the sequences on the new install. ?
Try using xlights (turn on lightbulb) and see if its xlights, if XL works then try xschedule.
Cheers Boof63

My alphapix is working. I tested the lights from it. My computer does see the alphapix. I have the lightbulb on. I’ll try re-rendered my sequences. Thanks!


Sent from my iPad using Tapatalk

4

General Software / Re: xlights doesn’t see my lights!

« on: December 21, 2018, 05:38:47 PM »

Did you turn the light bulb on?  (in xScheduler)

Yes I had the light bulb on. Everything was working before xScheduler. I was setting up my 4 sequences to do a show. Not sure what happened but xLights stopped seeing my lights. I reinstalled xLights and nothing! I’m new to this. What could I do now?


Sent from my iPad using Tapatalk

5

General Software / xlights doesn’t see my lights!

« on: December 21, 2018, 02:09:14 PM »

xlights doesn’t see my lights!
I made about 4 different Sequences and went to use xSchedule. Then my lights stopped working. After it stopped I checked everything. I did find a blown fuse on the AlphaPix. I replaced it. My computer (Win 10) sees the 4 Port Ethernet to SPI Controller. The light test works from the controller. I reinstalled the xLights. Still nothing! Where should I look? I’m using xLights with HolidayCoro/AlphaPix and 2811 pixels.


Sent from my iPad using Tapatalk