1
Bugs in xLights/Nutcracker / Re: Graphical issue with draw submodel
« on: December 28, 2020, 06:09:02 PM »
YES!!! Thank you Gil!! That worked!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Bugs in xLights/Nutcracker / Re: Graphical issue with draw submodel
« on: December 27, 2020, 05:39:17 PM »
Here you go, hope this helps. Thanks!
3
Bugs in xLights/Nutcracker / Graphical issue with draw submodel
« on: December 26, 2020, 11:07:00 AM »
https://imgur.com/a/Tgeb4Kq
Hopefully, this is repeatable by someone else. I can not get the draw sub model grid back to repeat it myself. This happened when I was zooming out in the select nodes submodel window. I think I zoomed out too far and now I've lost the grid. I've reinstalled Xlights, updated to newest version of windows 10 64x and xlights. This window has been this way for me for a while, probably 3 releases have passed since I lost the grid.
Hopefully, this is repeatable by someone else. I can not get the draw sub model grid back to repeat it myself. This happened when I was zooming out in the select nodes submodel window. I think I zoomed out too far and now I've lost the grid. I've reinstalled Xlights, updated to newest version of windows 10 64x and xlights. This window has been this way for me for a while, probably 3 releases have passed since I lost the grid.
4
Enhancement Requests / Effect time length
« on: February 07, 2017, 09:00:14 AM »
Is it possible to somewhere show how long an effect is running with in a sequence. For instance, you select an effect in the sequence and xlights says the effect is running for 2 seconds. This would allow me to give it the correct time length when layer blending.
The reason I'm asking, I'm about halfway through working on a sequence and suddenly saving is taking a little over a minute. I ran a sequence check a found I had 435 errors because the fade outs were .2 seconds greater than the time that the effects are (lots of copy and pasting).
I went back and fixed it but I'm still having having problems with long render times. I'm working on figuring that out.
The reason I'm asking, I'm about halfway through working on a sequence and suddenly saving is taking a little over a minute. I ran a sequence check a found I had 435 errors because the fade outs were .2 seconds greater than the time that the effects are (lots of copy and pasting).
I went back and fixed it but I'm still having having problems with long render times. I'm working on figuring that out.
Pages: [1]