Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - karljohnson33

Pages: [1]
1
Do You Need Help? Post it here / LED Strip Question
« on: December 01, 2017, 09:50:24 AM »
Does anyone know if a bad ws2811 pixel can cause the rest of the strip to fail? I have one led strip on my mega tree that only works about a quarter of the way through. Then, the rest of the leds are blank. Is it possible that cutting out the first blank pixel will fix the rest of the strip? Thanks.

2
Do You Need Help? Post it here / Re: RGB Matrix Color Question
« on: May 14, 2017, 08:16:23 PM »
Good call fellas! Just changed the channels per universe to 510 and it works like a charm. Thanks!

3
Do You Need Help? Post it here / RGB Matrix Color Question
« on: May 14, 2017, 06:17:50 PM »
I'm having trouble getting the correct colors on my matrix. I'm using xlights with an e682 controller. I have 16 strands of 50 pixels. When I test via the controller's page, the colors are all correct. However, when I output colors from xlights, each universe is different. I attached a picture where the matrix should show all red. Universe 1 is red, universe 2 is green, 3 is blue, etc. Any advice?

Pages: [1]