Messages

1

Do You Need Help? Post it here / Re: Cube around mesh

« on: February 12, 2021, 11:37:05 AM »

Hoping to give this a little bump.

Is it possible to rotate the boundary box around the mesh (without moving the mesh) - or does it not matter and I should chill out?

Thanks

2

Do You Need Help? Post it here / Re: Cube around mesh

« on: February 11, 2021, 06:21:47 AM »

Thank you for the response.

I have been doing that, but the boundary box and mesh move and rotate as one, so the relationship never changes. Is there a way to move them independently that I'm missing?

3

Do You Need Help? Post it here / Cube around mesh

« on: February 10, 2021, 03:55:34 PM »

Hi, all,

If my "cube" around my mesh model is 45 degrees off, does that mean by obj file came in incorrectly and I should (somehow) adjust in sketchup?

Thanks,
Ray

4

Do You Need Help? Post it here / Re: 3D tick box?

« on: February 10, 2021, 06:58:36 AM »

Thanks, all!

5

Do You Need Help? Post it here / Re: 3D tick box?

« on: February 09, 2021, 03:53:46 PM »

Got it - well, not sure then. I know I've seen the box before. I've attached a screenshot just in case I'm looking in the wrong place, but believe it should be next to the OBJ button.

6

Do You Need Help? Post it here / Re: 3D tick box?

« on: February 09, 2021, 12:50:13 PM »

Hi, Gil - I've just watched your video.

Yes sir, I've seen it before and have played - but it doesn't appear to be where it normally is. Maybe I'll try reinstalling and starting in a fresh show file.

Thank you,
Ray

7

Do You Need Help? Post it here / 3D tick box?

« on: February 09, 2021, 11:57:21 AM »

Hello - I've been searching, but haven't found anything - apologize if this is known. I no longer have the 3D tick box in the layout tab. Any thoughts? Thanks.

Ver 2021.04